10/20/2023 0 Comments Butt joint flat baseboardsBut the techniques in cutting a 45º on a miter saw still apply. After nailing wipe away any excess glue.Ĭorners are a little more complex. Apply wood glue to the joint to ensure that your two pieces of baseboard become one solid piece. To avoid splitting do not nail thru the scarf joint. This way you can nail both sides of the joint into the stud for stability(see graphic below). It is an alternative to other joints such as the butt joint and the splice joint and is often favored over these in joinery because it yields a barely visible glue line.īefore you cut you need to have all splices occur on a wall stud. So how do you splice? You use a technique called a scarf joint.Ī scarf joint (also known as a scarph joint) is a method of joining two members end to end in woodworking or metalworking. The scarf joint is used when the material being joined is not available in the length required. The splice would open up during a contraction period(normally cold weather) and your eye would catch that gap very easily. Now you could just butt joint at the splice but this would be a mistake. Most of the time the room dimensions will require splices in the baseboard. I also wear hearing protection and safety glasses when using it. I do a practice cut(without power) to see where my fingers are in relation to where the blade will be for every cut. Be sure to keep your hands well away from the blade. Safety FirstĪ miter saw is loud, spewing sawdust everywhere, and potentially dangerous to your person for every cut. A nail set will drive the last bit of exposed nail below the surface. If you’re going this route use a thin piece of wood(hole drilled thru it) to protect your baseboard from hammer blows during the nailing process. Yes, you could use a hammer and finish nails but you will need to predrill all nail holes. You need the miter saw for accurate cuts and the air nailer is needed to drive the nails in quickly so the two pieces of the molding do not move during the nailing process. To get the best results for splices and corners you will need a power miter saw and a finish air nailer. Snip off the head of a nail and use it as an improvised drill bit for best results.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |